Callisto Knowledge Base

This page is optimized for desktop computers and tablets. To access it, try one of the following points:

  • Access this page from a different device.
  • If you’re on a tablet, rotate it.
  • Check the “Desktop site” option in your browser settings.
Return to CTModule homepage
Knowledge Base
BabyPhone › Administration manual

Settings

Table of Contents

The general configuration for BabyPhone is found in the Settings tab. These settings are applied for all phones that use this BabyPhone instance.


Volume Threshold The noise level at which the alarm gets triggered. Takes a value between 50 and 2000; A lower value means the alarm gets triggered at a lover noise level.
Measurement Period Set in milliseconds between 500 and 1000. The interval at which the noise level is measured.
Initial Alarm delay Set in seconds. Set the delay after activating BabyPhone before it starts observing the noise level.
Alarm gap Set in seconds. The interval to wait after triggering an alarm and before triggering the alarm again.
Maximum concurrent observations. The maximum number of simultaneously executable observations (i.e., active noise level checks).
Maximum concurrent actions The maximum number of simultaneously executable actions (i.e., alarm calls and call-ins).
Maximum duration of observation Set in minutes between 60 and 1440. The time after which observation mode is automatically terminated. Set to 0 to disable automatic termination.
Notify end observation If checked, guest will receive a notification after observation mode is terminated.
Caller Name The name to display when a phone receives an alarm call from BabyPhone.
Reset PIN The PIN to use for resetting the cabin number on BabyPhone Mobile.
Automatically delete reports after Set in days. The period after which BabyPhone reports get deleted.